7.2
CLEAN FACE TRIM KIT INSTALLATION EXCLUDING GD36M
The "wave" clean face surround kit is shown in all illustrations.
From the rear side of the clean face front, insert the weld studs on the top window plate assembly
A.
upward through the holes on the underside of the top section of the clean face front.
Using a socket wrench, secure using the nuts and washers provided.
B.
Depending on your surround, space may be tight.
First secure the clean face surround to the appliance front by hooking the ledge that runs horizontally
C.
on the rear surface of the clean face surround over the bottom edge of the appliance front opening.
With the clean face surround against the appliance front, hook the surround clips in behind the top
D.
lip of the appliance front opening and secure using the screws provided through the slot in the sur-
round clip and into the pre-drilled hole in the clean face surround. If the optional clean face trim kit was
installed, the surround clip fi ts into the cut out and is secured in the same fashion.
41
EN
W415-1132 / C / 08.20.13