Finishing; 7.5 Convex Front Trim Kit Installation - Napoleon GRANDVILLE BGD36CFNTR Manuel D'installation Et D'utilisation

fi nishing
EN
7.5 convex front trim kit installation (optional)
A. From the rear side of the clean face front, insert the weld studs on the top window plate assembly
upward through the holes on the underside of the top section of the clean face front.
B. Using a socket wrench, secure using the nuts and washers provided.
Depending on your surround, space may be tight.
C. First secure the clean face surround to the appliance front by hooking the ledge that runs horizontally on
the rear surface of the clean face surround over the bottom edge of the appliance front opening.
D. With the clean face surround against the appliance front, hook the surround clips in behind the top lip of
the appliance front opening and secure using the screws provided through the slot in the surround clip
and into the pre-drilled hole in the clean face surround. If the optional clean face trim kit was installed, the
surround clip fi ts into the cut out and is secured in the same fashion.
38
W415-1345 / D / 05.01.17