Inside the combustion chamber of the wood fired
thermostove are placed some mobile steel sheets
that have a double function: they allow the en-
trance of the secondary air after-combustion at an
optimal height for the reduction of the emissions
and they protect the integrity of the boiler acting
as protective shield between the flame and the wall
of the boiler.
Anytime it is necessary a deeper ash cleaning, when
the thermostove is cold it is possible to remove
these sheets. To do this, it is necessary to remove
5.5
GRILL CLEANING
Every time you use the thermostove you have to
clean the wood carrying grill before, at least you
have to clean the more rough deposits: the holes
of the grill should not be obstructed. To make this
you can use the poker given together with the
5.6
ASH BOX
Every time you use the thermostove you have to
check the ash box located under the combustion
chamber. When the box is full, you have to emp-
ty it, checking carefully that there are not lighted
embers. If you do not empty it, the ash accumu-
5.7
OVEN CLEANING (T CHEF SERIES)
Before cleaning it is recommended to remove both
the baking pan of the oven. For an accurate clean-
ing, it is possible to remove also the lateral grills,
Picture 28 – Oven cleaning.
5.8
FUME-CIRCUIT CLEANING
Cleaning the fume circuit inside the thermostove
must be done in correspondence with the chimney
A
94
the sheets starting from the sides of the combus-
tion chamber and last the ones placed in the rear
part, unhooking them from the pin and unthreading
them up. The frame on which the plates rest is to be
cleaned, so as to prevent the ash from depositing
and obstructing the secondary air duct.
To reassembly the sheets it is necessary to do the
reversal operation, paying attention to insert them
in the correct position and in the correct order,
placing in the first time the base and then hooking
them to the pin.
thermostove. If the grill is not well cleaned, the
flame could not be well feed and so you could ex-
perience an irregular combustion. If the grill is be-
ing removed, it must be placed in its housing with
the flat part turned upwards.
lates itself and makes the cleaning more difficult.
In case of excessive cinders the flame could not
be well fed and you could experience an irregular
combustion.
lifting them up and unthreading them upwards.
The oven must be cleaned with products available
in the commerce.
B
cleaning. With the cleaning, all the deposits of ash
and soot are removed. For this reason, it is neces-