Überlastschutz; Overcurrent Protector; Protection En Cas De Surcharge - Ismatec BVP-Z Standard Mode D'emploi

Moteur de pompe à engrenages à vitesse variable
Table des Matières

Publicité

BVP-Z STANDARD, 14-005, REV D
Überlastschutz
Die Pumpe BVP Standard besitzt
eine Überlast-Sicherung.
Bei aktiviertem Überlastschutz stoppt die
Pumpe und die Kontroll-Lampe blinkt.
(siehe auch Beschreibung von Pin 12
der Analogschnittstelle auf Seite 12).
In einer solchen Situation ist die
Pumpe sofort mit dem Netz-
schalter auszuschalten.
X
Abkühlen lassen (es dauert ca. 2 Min.,
bis die Pumpe wieder betriebsbereit ist).
Bevor die Pumpe wieder gestartet
wird, ist unbedingt zu prüfen, was die
Überlastung der Pumpe verursacht hat
(z.B. zu hoher Differenzdruck).
X
Erst nachdem die Ursache für die
Überlast behoben worden ist, darf
die Pumpe neu gestartet werden.

Overcurrent protector

The tubing pump BVP Standard
features an overload protector.
When the overcurrent protector
is activated, the pump is stopped
and the control light flashes (see
the description of Pin 12 of
analog interface on Page 12).
Whenever this situation occurs,
the pump must be switched
OFF immediately.
X
Let the pump cool down
(it takes about 2 minutes until
the pump is ready again).
Before the pump is re-started,
it is most important to check
the reason for the overload
(eg. too high differential pressure).
X
Only when the cause of the
overload has been detected and
the failure corrected accordingly
may the pump be started again.

Protection en cas de surcharge

La pompe BVP Standard possède
une protection de surcharge.
Lorsque la protection de surcharge
est activée, la pompe s'arrête et la
lampe de contrôle clignote (voir
aussi la description du Pin 12 de
l'interface analogique en Page 12).
Dans une telle situation, la pompe doit
étre immédiatement déclenchée.
X
Laisser refroidir (la pompe
est à nouveau prête à fonctionner
après environ 2 min).
Avant d'enclencher à nouveau la pompe,
il est indispensable de contrôler ce qui a
pu provoquer la surcharge (ex. pression
différentielle trop élevée).
X
La pompe ne doit être remise
en marche qu'après l'identification
de la cause de la surcharge et la
réparation correspondante du défaut.
10 of 25

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ism446

Table des Matières