Securing And Installation Options - Phoenix Mecano RK Rose+Krieger LZ 70 P Notice D'assemblage

7.4.3 Securing and installation options

The specific tightening torques for the screws must be observed during all assembly work. Note
the strength of the screws and separate information for accessories supplied. Only by observing
the conditions can safety and service life be guaranteed for the electric cylinder.
The profile grooves on the guide profile are closed with a cover profile. To fit add-on components
to the profile grooves, fig. 4 to fig. 6, the cover profile should be removed.
Through the two end openings in the covering cap, you can insert RK slot nuts version "N" for the
nut geometry 30, with threads M6 or M5 into the guide profile (fig. 4).
Magnets are already fitted as standard into the electric cylinder to operate magnet switches.
To fasten fork and joint heads to the push rod, a trunnion mounting with a bearing block to fit
the cylinder is available.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
7. Life Phases
59