Phoenix Mecano RK Rose+Krieger LZ 70 P Notice D'assemblage page 58

7. Life Phases
Measure the toothed belt tension
The values in the table should be observed.
Toothed belt
Axle separation
Frequency value
New belt
Frequency value used
belt
See the measuring equipment instructions on how to make the measurement correctly.
Correcting the toothed belt tension
•
Loosen the fastening bolts of the locking plate.
•
Maximum distance between adapter and housing = 0.20 mm.
•
Screw in the tensioning screw (fig. 7).
•
Tighten up the fastening bolts of the locking plate to 10 Nm (fig. 8).
•
Measure the toothed belt tension.
Repeat the installation steps to set the toothed belt tension until the values specified in the
toothed belt tension table are measured.
58
GT3 5MGT - 25 mm wide
90 mm
min. 317Hz
max. 333Hz
min. 266Hz
max. 284Hz