Installation Of The 8222 Onto The Pipe - Burkert ELEMENT 8202 Mode D'emploi

Type 8202/8222
Fig. 15: Mounting the electronic module to the sensor holder, after
installation of the holder on a fitting (8202)
8.3. installation of the 8222 onto the
pipe
danger
risk of injury due to high pressure in the installation.
• Stop the circulation of fluid, cut-off the pressure and drain the
pipe before loosening the process connections.
risk of injury due to the nature of the fluid.
• Respect the regulations on accident prevention and safety rela-
ting to the use of aggressive fluids.
→
Select an appropriate position on the pipe (prefer "A" mounting
to install a 8222 with sensor C=0.1 or C=0.01).
Installation
→
Apply slight vertical
pressure to engage the
seal.
→
Fasten the electronic
module and the holder
together by tightening
the nut. Tighten the G 2''
nut by hand only, until it
stops turning, to ensure
good electrical contact
with the temperature
probe.
A
Direction of the fluid
Fig. 16: Mounting positions of the 8222 in the pipe
→
Mount the display module to calibrate and configure the
transmitter.
→
Calibrate the transmitter.
→
Mount the transmitter into the fitting, as shown in Fig. 17:
English
B
23