Mount Attachment Components - Festo ELGA-BS-KF Notice D'utilisation

ELGA-BS-KF
Interfaces for mounting components
On the cover
e.g. with foot mounting HPE
1) Accessories è www.festo.com/catalogue
Fig. 6
Note
Danger of screws being pulled out if the axis is only mounted to the covers and the
torque load around the longitudinal axis is too great.
• If there is high loading, mount the axis on the profile with additional mounting com­
ponents.
• Select mounting components (è www.festo.com/catalogue).
• Mount the mounting components outside the positioning range (avoid collisions).
• Fasten axis.
• Evenly tighten screws.
Size
Screw (cover)
Tightening torque
Tab. 1
5.1.2

Mount attachment components

Requirements
Note
A warped attachment component bends the slide
and shortens the service life of the guide.
• Use an attachment component with an even
surface.
Evenness: t = 0.01 mm
26
On the profile
1)
e.g. with slot nuts NST
70
M5
[Nm] 6
1)
e.g. with profile mounting MUE
80 120
M8
24
Fig. 7
Festo – ELGA-BS-KF – 1508NH English
1)
150
t