Mounting The Axis - Festo ELGA-BS-KF Notice D'utilisation

ELGA-BS-KF
Mounting position vertical or diagonal
WARNING
Uncontrolled payload in the event of a power failure
or spindle nut fracture.
Injury due to impact or pinching.
With vertical or diagonal mounting position:
• Use motors with spring-loaded holding brakes.
• Take appropriate safety measures to prevent
damage as a result of spindle nut fracture (e.g.
toothed latches, bolts or an emergency buffer).
5.1.1

Mounting the axis

Requirements
• Position the product in such a way that its control sections are accessible (e.g. relubrication openings).
• Install product without tension or distortions.
• Fasten product to a mounting surface with flatness of 0.05 % of
the stoke length, but max. 0.5 mm.
For gantry applications, attention must also be paid to parallel
alignment or product heights in alignment of the axes.
For additional information, contact your local Festo Service.
• Take the required support clearances into consideration
(è 13 Characteristic curves).
Festo – ELGA-BS-KF – 1508NH English
Fig. 4
Fig. 5
25