Safety; Intended Use; General Safety Information; Mounting And Connecting - Festo ELGA-BS-KF Notice D'utilisation

ELGA-BS-KF
2

Safety

2.1

Intended use

The axis is intended to be used for positioning payloads in combina­
tion with tools or as a drive when external guides are used.
The axis is approved for slide and yoke operating mode (è Fig. 2).
2.2

General safety information

• Take into consideration the legal regulations applicable for the location.
• Only use the product if it is in its original condition and in an excellent technical status.
• Use the product only within the defined values (è 12 Technical data and 13 Characteristic curves).
• Take into account labelling on the product.
• Do not make any unauthorised modifications to the product.
• Observe other applicable documents.
• Take into consideration the ambient conditions at the location of use.
Protect the product during storage and operation from the following:
– Wetness or moisture
– Corrosive coolant or other materials (e.g. ozone)
– UV radiation
– Oils, greases and grease-solvent vapours
– Grinding dust
– Glowing chips or sparks
2.3

Mounting and connecting

• Observe tightening torques. Unless otherwise specified, the tolerance is ± 20 %.
2.4

Qualified personnel

Only qualified personnel may perform installation, commissioning, maintenance and disassembly of the
axis. The qualified personnel must be familiar with installation and operation of electrical and pneumat­
ic control systems.
Festo – ELGA-BS-KF – 1508NH English
Fig. 2
23