Par. 5; Supplied Accessories; Pushbuttons And Display On The Control Panel; Replacing The Printer Roll - Tecno-gaz ANDROMEDA VACUUM xp 20 Mode D'emploi

PAR. 3

SUPPLIED ACCESSORIES

The autoclave is sold with the accessories included
in the article and contained in the same package;
here is a list of these accessories.
PIECE No.
1 Tray extraction and door adjusting key
4 Tray
1 Instruments holder
1 Funnel
1 Tank outlet hose
1 Rilsan hose
1 Sponge
1 Tray holder
1 Loading hose + filter
THE EQUIPMENT LISTED ABOVE DO NOT
REQUIRE ADVICES
NOTE: FOR ALL REFERENCE AT THE OPERATIONS SPECIFIED ON THIS MANUAL, TO KEEP AT
THE PRESENT TABLE.

PAR. 5

To replace the printer roll, it is necessary to open the door on the autoclave front panel, insert a roll of
thermal paper (whose maximum width must be of 57 mm) in the suitable place making the paper come out
from the door while it is closed.
After the sterilisation cycle, the autoclave finishes to print the convalidation ticket; after printing, cut the ticket
by pulling it upwards. The cutter built in the printer will cut the ticket.
Pay attention to the thermal paper orientation sense; it can be printed only on one side.
For a correct and long storage of the sterilisation ticket, it is necessary to preserve the same in a
place protected by light and heat sources.
DESCRIPTION

REPLACING THE PRINTER ROLL

PAR. 4
PUSH-BUTTON AND DISPLAY ON THE
CONTROL PANEL
The positions indicated on the table are referred on
the pictures at the page 3 of the cover.
1A
Display DATE
Display H – MM
2A
3A TEMPERATURE Display
4A TIME/MESS Display
5A 134°C cycle Led, not wrapped
6A 134°C cycle led, wrapped
7A 121°C cycle Led, not wrapped
8A 121°C cycle Led, wrapped
9A 134°C cycle Led, SPECIAL
10A Clean water Led, maximum level
11A Used water led, maximum level
12A 0/1 (START/STOP) push-button
13A Cycle selection push-button
14A Door opening push-button
15A Clean water Led, minimum level
16A Push-button for water loading in the clean
water tank
17A ON/OFF main switch
18A Door opening handle
19A Adjusting feet
20A Autoclave door
21A Printer
22A Cap manual filling
23A Discharge tap
24A PRESSURE Display
25A Water loading plug
17 DNVT008 Rev_5