Commissioning - SOMFY Oximo 40 Wirefree WF RTS Notice

EN

2.3. COMMISSIONING

Before commissioning, check if the product is in stand-by by pressing the Up or Down button. If the motorised
product does not respond, it is in stand-by (see step 2.3.5 to activate it).
Identifying the steps to follow
The end limit setting depends on the type of roller blind:
For a roller shutter with rigid links
and with stops
No adjustment necessary: the end limits are
set automatically.
Check the robustness of the roller
shutter and its fittings.
For information about the compatibility
of the drive with the roller shutter and
accessories, contact the roller shutter
manufacturer or Somfy.
Step 3:
Automatic setting of end limits
(2.3.3.a)
28
Step 1: Pre-programming the control point (2.3.1)
Step 2: Controlling the direction of rotation (2.3.2)
For a roller shutter without rigid
links and without stops
The upper and lower end limits must be set in
manual mode.
Setting the end limits in manual
Step 4: Programming the control point (2.3.4)
Images not contractually binding
Step 3:
mode (2.3.3.b)
OPERATION
For a roller shutter without rigid
links and with stops or with rigid
links and without stops
The upper or lower end limits must be set in
semi-automatic mode.
Step 3:
Setting the end limits
in semi-automatic mode (2.3.3.c)
Copyright © 2017 Somfy SAS. All rights reserved.