Torch; Set Date / Time (Hs); Setting The Time; Setting The Date - HumanTechnik freeTELeco Mode D'emploi

Masquer les pouces Voir aussi pour freeTELeco:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 54

Torch

The telephone has a torch function. To turn
this on, hold the
3 seconds.
Follow the same procedure to turn the func-
tion off again.

Set Date / Time (HS)

Setting the time

1. Press the "Menu" key and select the
entry "HS Settings" with
2. Now press "Select".
3. Select "Date & Time" and confirm with
"Select".
4. Select "Set Time" and confirm with "Se-
lect".
5. Enter the time over the selector key and
press "Save" to complete the setting.

Setting the date

1. Press the "Menu" key and select the
entry "HS Settings" with
2. Now press "Select".
3. Select "Date & Time" and confirm with
"Select".
4. Select "Set Date" and confirm with "Se-
lect".
5. Enter the date over the numerical keys
and press "Save" to complete the setting.

Set Time Format

1. Press the "Menu" key and select the
entry "HS Settings" with
2. Now press "Select".
3. Select "Time Format" and confirm with
"Select".
4. With
chose from 12-hour and 24-hour
and press "Save" to complete the setting.
44 English
key down for around
.
.
.

Setting the Date Format

1. Press the "Menu" key and select the
entry "HS Settings" with
2. Now press "Select".
3. Select "Date Format" and confirm with
"Select".
4. With
chose from DD-MM and MM-DD
and press "Save" to complete the setting.

Additional functions (HS)

Registering a new handset

The handset which was delivered is alrea-
dy registered on the base. This is registered
as handset 1. Each additional handset that
you purchase must first be registered on the
base station.
Up to 5 base stations can be registered on a
base station. You can then also make inter-
nal telephone calls between the handsets.
You can also forward incoming calls to other
handsets.
You can register up to 4 base stations on
each handset. This increases the range of
the telephone so that you can move bet-
ween the telephone transmission areas.
To register a new handset, proceed as fol-
lows:
1. Press and hold the „MT-Search"-button,
located at the underside of the base, for
approximately 5 seconds until a beep can
be heard.
2. Press the key "Menu" and select the
entry "Registration" with
3. Now press "Select".
4. With
select the preferred base and
confirm with "Select". The base station is
now located and the handset is registe-
red.
5. Now enter the PIN code (default is
0000).
6. If the PIN code is accepted, a log-on
tone sounds and the base assigns a
number to the handset. If the PIN code is
.
.

Publicité

Table des Matières
loading

Table des Matières