Renaming The Handset; Display Contrast; Automatic Call Answering; Adjust Amplification - HumanTechnik freeTELeco Mode D'emploi

Renaming the handset

The standard name of the handset is "HS n"
(n is a number from 1 to 5). This number in-
dicates that the handset is registered as the
n th handset on the base. HS 1 is registered
on the base as the 1
The name of the handset is displayed in
standby mode.
1.Press the "Menu" key and select the entry
"HS Settings" with
2. Select "HS Name".
3. Now press "Select".
4. Enter the name and complete the setting
with "Save".

Display contrast

1. Press the "Menu" key and select the
entry "HS Settings" with
2. Now press "Select".
3. Select "LCD Contrast" and confirm with
"Select".
4. Select the preferred contrast from 0 to
16 with and complete the setting with
"Save".

Automatic call answering

With automatic call answering, you can ac-
cept a call without pressing any key by lifting
the handset out of the charging station.
1. Press the "Menu" key and select the
entry "HS Settings" with
2. Now press "Select".
3. Select "Auto Answer" and confirm with
"Select".
4. Select "On" or "Off" and complete the
setting with "Select".
st
handset.
.
.

Adjust amplification

The normal range of the volume setting is
from 0 to 15 dB. When amplification is swit-
ched on, the volume is increased to 15 to
30 dB.
1. Press the "Menu" key and select the
entry "HS Settings" with
2. Now press "Select".
3. Select "Amplified" and confirm with "Se-
lect".
4. Select "On" or "Off" and complete the
setting with "Save".

Select base

You can select a base on which the handset
is already registered. You can only select
bases, which are already registered on the
handset.
1. Press the "Menu" key and select the
entry "HS Settings" with
2. Now press "Select".
3. Select "Selected BS" and confirm with
"Select".
4. Select from the different bases with
and confirm with "Select". The preferred
base is now located and set.

Reset settings

1. Press the "Menu" key and select the
entry "Default" with
2. Now press "Select".
3. Now enter your PIN code and press
"Select".
4. Confirm with "Select"
Turning on vibration and flash
In addition to the ringtone, you can turn on
the vibration alarm and flash.
To do this, hold the
on the vibration and flash.
Follow the same procedure to turn the func-
tion off again.
.
.
.
for 3 seconds to turn
English 43