Mode "Time" (Time); Select Function; Set Time, Date, 12H/24H-Mode - Conrad Kit W-210 Notice D'emploi

11. Mode "TIME" (time)

a) Select function
• If the pulse watch does not show the time, push the button (B)
"MODE" briefly repeatedly until the display shows "TIME". After
approx. 2 seconds, the time and date are shown automatically.
• Then the button (D) "RESET" can be used to switch between
week day and month.
b) Set time, date, 12h/24h-mode
• To set the clock, keep the button (A) "ADJ/EL" pushed for
approx. 2 to 3 seconds. While the button is pushed, the dis-
play shows "ADJUST HOLD". Once the time is displayed and
the hours flash, release the button again.
• You are now in setting mode. The order of what can be set in sequence (hours, minutes,
seconds, year, month, day and 12 or 24 hours mode) can be taken from the following image.
52