Checchi & Magli TRIUM Manuel D'utilisation Et D'entretien page 72

Tyres check
Check the tyres for wear and if they feature tears or signs
of ageing, they must be replaced.
Check tyres pressure and restore if necessary (see "Tech-
nical characteristics" schedule).
Cleaning the work vehicle
Clean the work vehicle with a high-pressure water jet
and, if necessary, with approved detergents.
The liquid used for washing could be hazardous for the
environment due to the presence of pollutants such as
detergents, oils, etc., therefore do not simply dump the
Troubleshooting
The following list contains a number of common problems that may arise during work, together with the ways to
solve them.
Problem
The seedling planted is too close to
the surface or too deep
The soil has not been properly
compacted on top of the seedlings
The seedling is planted at an angle
The seedling is lying overturned on
the ground
English language
MAINTENANCE INFORMATION
The pressure must be checked with the weight of the
work vehicle entirely on the ground and with nothing
and nobody on the work vehicle.
wastewater; dispose of it in suitable areas equipped with
separation devices for the pollutants.
Dry with compressed air and lubricate the components
shown (see "Lubrication points diagram").
Likely cause
Incorrect planting depth
The dispenser is not synchronised
with the ejector
The packing wheels are not
properly adjusted
The dispenser is not synchronised
with the ejector
The plant control plate is not in the
right position
The plant control plate is outside
the ploughshare
30
Solution
Make the relative adjustment (see "Ad-
justing the planting depth")
Adjust the timing (see "Adjusting the
dispenser / ejection timing")
Adjust the packing wheels (see
"Adjusting the spacing between the
packing wheels and the ploughshare")
Adjust the timing (see "Adjusting the
dispenser / ejection timing")
Adjust the plant control plate (see
"Plant control plate adjustment")
Position the plate inside the
ploughshare
7
Use and maintenance