6.2
Malfunctions
If malfunctions occur, check whether:
→
the device has been installed according to the instructions,
→
the electrical and fluid connections are correct,
→
the device is not damaged,
→
all screws have been tightened,
→
the voltage and pressure have been switched on,
→
the pipelines are clean.
Malfunction
Possible cause
Valve does not switch Short-circuit or coil interrupted
Medium pressure outside the permitted
pressure range
Manual emergency actuation locked
Valve does not close
Internal space of the valve is dirty
Manual emergency actuation locked
7.2
Exploded drawing
12
Pilot valve
SET 3
english
7
SPARE PARTS
CAUTION!
Risk of injury and/or damage by the use of incorrect parts!
Incorrect accessories and unsuitable spare parts may cause injuries
and damage the device and the surrounding area.
• Use original accessories and original spare parts from Bürkert only.
7.1
Ordering spare parts
Replacement part sets
Order the spare-part set SET 3 or the pilot control with solenoid coil (com-
plete) by quoting the identification number of the device.
• See replacement part sets "7.2 Exploded drawing".
• The identification number of the device can be found on the type label.
See also chapter "4.5 Type label".
english
8
TRANSPORT, STORAGE,
DISPOSAL
NOTE!
Transport damages!
Inadequately protected equipment may be damaged during transport.
• During transportation protect the device against wet and dirt in
shock-resistant packaging.
• Avoid exceeding or dropping below the allowable storage
temperature.
Incorrect storage may damage the device.
• Store the device in a dry and dust-free location!
• Storage temperature: -40 °C ... +80 °C
Damage to the environment caused by device components
contaminated with media.
• Observe applicable regulations on disposal and the environment.
• Observe national waste disposal regulations.
→
Dispose of the device and packaging in an environmentally friendly
manner.
Type 5282
11