Spare Parts - Burkert 6213 Manuel D'utilisation

9. malfuncTiOns
If malfunctions occur, check whether:
→
the device has been installed according to the
instructions,
→
the connection has been made properly,
→
the device is not damaged,
→
all screws have been tightened,
→
the voltage and pressure have been switched on,
→
the pipelines are clean.
If the magnet is not attracting
Possible causes:
• Short circuit or coil interrupted,
• Core or core area dirty.
After occurrence of an external fire
• After an external fire, check equipment and safety device.
• If there is visible damage, replace safety device.
english
20
11. packaging, TranspOrT,
sTOrage, dispOsal
note!
Transport damages!
Inadequately protected equipment may be damaged
during transport.
• During transportation protect the device against wet
and dirt in shock-resistant packaging.
• Avoid exceeding or dropping below the allowable
storage temperature.
Incorrect storage may damage the device.
• Store the device in a dry and dust-free location!
• Storage temperature. -30 ... +80 °C.
Damage to the environment caused by device compo-
nents contaminated with media.
• Dispose of the device and packaging in an environ-
mentally friendly manner.
• Observe applicable regulations on disposal and the
environment.
• Observe national waste disposal regulations.
english
22
All manuals and user guides at all-guides.com

10. spare parTs

Caution!
Risk of injury and/or damage by the use of incorrect
parts!
Incorrect accessories and unsuitable spare parts may cause
injuries and damage the device and the surrounding area.
• Use original accessories and original spare parts from
Bürkert only.
Nut
Coil set
Fittings set
Fig. 5: Spare parts
Type 6213
• Nut and coil set can
be ordered completely
by quoting the identi-
fication number of the
device (see type label).
• Fittings set on request.
english
21