Getting To Know The Autoset Plus; Jigging System Overview - Alpine AutoSet Plus Manuel

Option 2: (Figure 2)
8 Automated axis per table, and
4 manual axis per table
• O.C. spacing between two automated axis is
10-1/2in.
• Each manual baseline axis is centered between
two automated axis.
Figure 2
2. Getting to Know
the AutoSet Plus
2.1.

Jigging system overview

Each table consists of manual and automated pucks.
The manual pucks are set in position and adjusted as
needed using a ¾" wrench to loosen/tighten the pucks.
The automated pucks are directly driven to position
using a servo motors and lead screws. The automated
pucks move to positions identified by the software.
7
EN
AutoSet Plus
P R O D U C T M A N UA L
Figure 3