Alpine AutoSet Plus Manuel page 34

Figure 85
15. Install bearing plate. Center bearing on axis
such that the nut has play side to side in the
slot before tightening bearing plate (Figure 84)
NOTICE
Polish or file the shaft to allow the bearing to slide on if needed.
Do not tighten set screws at this time.
Figure 86
16. Install the automated puck (Section 6.5.1)
17. Remove lockout/tagout and power up to move
Puck to middle of table
!
Verify that all power to the machine has been turned off
following OSHA-approved lockout/tagout procedures
(OSHA REGULATION 29 CFR 1910.147).
18. Tighten down the set screws in the bearing
(Figure 87)
19. Install side plate - Place plate on tabs and push
down carefully
20. Remove lockout/tagout and power up
21. Calibrate the axis with the new nut (Section 5).
34
AutoSet Plus
P R O D U C T M A N UA L
WARNING
Figure 87
EN