Alpine Computer Maintenance; Remove And Replace C-Fast Card; C-Fast Card Storage; Adjusting The Liftout - Alpine AutoSet Plus Manuel

6.6.

Alpine Computer Maintenance

6.6.1. Remove and replace C-Fast Card

Use a T1O size Torx bit to remove the front cover plate
from the top of the computer.
Front cover plate removal points.
Locate the C-Fast card slot.
Push in on C-Fast card and release to remove existing
card (if present).
Insert the new C-Fast Card.
Replace cover after inserting the new C-Fast card.

6.6.2. C-Fast Card Storage

C-Fast cards not in the computer need to be stored in a
clean and dry location.
6.7.

Adjusting the Liftout

• The liftout adjustment is performed by tightening or
loosening the castle nut on both pivots. The objective
is to minimize the side to side movement of the arms
that raise the skate bars.
• Adjustment process:
1. Remove cotter pin.
2. Tighten castle nut until the arm cannot move.
3. Loosen the castle nut until the arm moves and
a cotter pin can be installed.
4. Install the cotter pin (use a new cotter pin every
time an adjustment is made).
4
3
4
2
1 Cotter Pin
2 Castle Nut
3 Thrust Washer
4 Standard Washer
The thrust washer (APN: 39737) is a wear item and should be
replaced if it gets less than 1/16" thick.
35
EN
AutoSet Plus
P R O D U C T M A N UA L
1
NOTE