General Specifications; Equipment Specifications (Figure 1); Electrical Specifications; Autoset Plus Spacing Options - Alpine AutoSet Plus Manuel

1.2.

General Specifications

1.2.1. Equipment Specifications (Figure 1)

Gantry Roller Face Width
Gantry Overall Width
Gantry Travel Speed
Table Length (Per table)
Table Width (Between Rails)
Maximum distance
between top and bottom
automated pucks
Truss Jigging Setups/Groups
Air Requirement
Operating Temperature

1.2.2. Electrical Specifications

Equipment Voltage
110
Conveyor
220
208 (Transformer)
Gantry 230 (Transformer)
480 (Standard)
AutoSet Plus Amperage Requirements
30 Amp per Gantry
20 Amp for the Controller Box
20 Amp per 16 Automated Axis
NOTE
Customer must provide transformer if other than 480V-3PH.
14 ft. 7 in.
18 ft. 7 in.
140 in./min.
7 ft. 1 in.
14 ft. 3 in.
12ft. 6 in.
1 to 4 groups per
system
2 CFM per liftout
at 100 PSI
(when activated,
not a constant draw)
32° to 104° F
Phase Amps
30
Single
15
25
Three 22
11
6
P R O D U C T M A N UA L

1.2.3. AutoSet Plus spacing options

Option 1: (Figure 1)
4 Automated axis per table, and
4 manual axis per table
• O.C. spacing between two automated axis is
1ft. 9-1/4in.
• Each manual axis is centered between two
automated axis.
Figure 1
EN
AutoSet Plus