Getting Data To The Autoset Plus; General; Network; Usb Device - Alpine AutoSet Plus Manuel

2.9.

Getting Data to the AutoSet Plus

2.9.1. General

Table setup information must be in ASD files format.
Most truss engineering software packages can develop
these files automatically. Contact the software supplier
for details. Alpine will supply the file specification for
these files if necessary.

2.9.2. Network

An Ethernet adapter card is provided with the computer
inside the console. Alpine recommends connecting the
network using a Cat 5 Ethernet cable.
Except for its distance from the server, the table
computer operates like other computers on the
network. Distance can be an issue, Alpine recommends
that the network cable is installed and connected by a
network professional.
If ASD files are being sent to the AutoSet Plus over a
network connection, it is mandatory that the table
computer be able to write to the ASD files to the
network. This is how completed setups are recorded.
The table will require certain network rights. If the
network administrator has questions, have them
contact Alpine Equipment Technical Support for more
information.
To receive live support, the AutoSet Plus computer
must have internet access. This will allow for remote
access by Alpine Equipment Technical Support for
troubleshooting and diagnostic evaluation.

2.9.3. USB Device

Sometimes called "jump drives" or "thumb drives",
these devices are necessary if the saw is not connected
to a network. The AutoSet Plus has a dustproof USB
port mounted on the front panel of the operator's
console for these devices. The AutoSet Plus program
communicates with these devices in the same manner
as it would to a hard drive or network connection.

2.10. HMI

1
2
3
1 Monitor
2 Power/Reset Button Push Button that resets
3 Keyboard
4 Emergency Stop
5 Mouse
6 USB Port
14
EN
AutoSet Plus
P R O D U C T M A N UA L
6
Standard or Touch Screen
system after E-stop
Safety E-stop push button
(stops all axis motion)
4
5