Vertical Dimension (Figure 47); Diagonal Dimension (Figure 48); Move Individual Puck - Alpine AutoSet Plus Manuel

3.8.2. Vertical dimension (Figure 47):

To create vertical dimension, click on the vertical
dimension icon then follow the steps below:
1. Click on a desired location to display the
vertical dimension
2. Click on first point
3. Click on second point
3
1
2
Figure 47

3.8.3. Diagonal dimension (Figure 48):

To create diagonal dimension, click on the diagonal
dimension icon then follow the steps below:
1. Click on a desired location to display the
diagonal dimension
2. Click on first point
3. Click on second point
Figure 48
1
3
2
3.9.

Move Individual Puck

All pucks are assigned a location on the outside profile
of the truss. Occasionally, it is useful to move a puck to
another location on a board inside the truss. To move an
individual puck, follow the steps below:
1. Select a puck to move by clicking on its axis,
the axis will turn red (Figure 49)
1
2. Click on the board that you want the puck to
brace.
3. A pop up box appears with two options: Top or
Bottom edge (Figure 50)
4. Select to the location where you want to locate
the puck.
For example, in Figure 51, the puck number 7 was
moved from the top edge of the top chord to the top
edge of the bottom chord.
23
EN
AutoSet Plus
P R O D U C T M A N UA L
Figure 49
Figure 50
Figure 51