Alpine AutoSet Plus Manuel page 17

Title Picture Description
Click to Home the pucks of the selected group.
Home Group can be selected by clicking of the group
button.
Click to Setup the truss using the pucks in the
Setup
selected group.
Click Toggle to move all the pucks to the Top
Chord side.
Toggle
Click Toggle again to return to alternating the
pucks between the top and bottom of the chord.
Stop Click Stop to stop puck movement.
Click to open the Maintenance and Tools Screen
Tools
(Section 3.6).
Exit
Click Exit to close the AutoSet Plus Program.
Click to list all available Toolbars.
Toolbars
From the list select which Toolbars to display on
the Main Menu
Click to temporarily adjust group size
Adjust Groups
(Section 3.6)
Click to activate Horizontal Dimension then click
Horizontal
two points in the horizontal direction to display
Dimension
the dimension.
Click to activate Vertical Dimension then click
Vertical
two points in the Vertical direction to display the
Dimension
dimension.
Click to activate Diagonal Dimension then click
Diagonal
two points in the diagonal direction to display
Dimension
the dimension.
Open Job Click to Open the Job Select Menu (Section 3.2)
Click to setup the truss using the pucks in
Group 1
Group 1.
Click to setup the truss using the pucks in
Group 2
Group 2.
Select a group then click a Open Truss to setup a
Open Truss truss on the group from the Select Truss Screen
(Section 3.3)
Previous Truss Click to go back one truss in the job.
Title Picture Description
Next Truss
Mark Done
E-Stop
Zoom In
Zoom Out
Zoom to
Corners
Zoom to Truss
Zoom to Table
System
Jog Truss Left
Jog Truss
Right
Jog Truss Up
Jog Truss
Down
Align Truss to
Baseline
Rotate Truss
Vertical
Flip Truss
Horizontally
Rotate Truss
17
AutoSet Plus
P R O D U C T M A N UA L
Click to advance to the next truss in the job.
Click to mark the truss complete in the job file.
The ESTOP tile will flashing RED when the E-Stop
button is pressed.
Click to Zoom the view in.
Click to Zoom the view out.
Click then select two points to Zoom the window.
Click to Resize the window to view the entire
truss.
Click to Resize the window to view the entire
table system.
Click to shift the truss setup left by one rod.
Click to shift the truss setup right by one rod.
Click to move the truss up 3 inches on the table.
Click to move the truss down 3 inches on the
table.
Click to align the bottom of the truss 15 inches
from the rail.
Click Rotate the truss vertically.
Click to flip the truss horizontally.
Click to rotate the truss based on a user-defined
angle and direction (Section 3.4.2).
EN