Daily Maintenance; Weekly Maintenance - Alpine AutoSet Plus Manuel

6.8.

Daily Maintenance

• Check for proper operation of all the following safety
devices:
– E-stops: E-stops are located on the HMI stands,
and on the controller box located approximately
on the center of the table system table (Section
2.8). These will stop the motion of the automated
axis and liftouts on the table system. An E-stop
can be tested by pushing in the E-stop and
checking if any axis moves.
– Limit switches: Limit switches are located on the
gantry "A" frame on the bottom chord side of the
table (Section 2.2), these will stop the motion
of the gantry. A limit switch can be checked by
manually actuating the switch while the gantry is
stopped, then trying to move the gantry.
WARNING
!
Do not check the limit switch while the gantry is in movement.
– Liftout Safety System (Section 2.5): Make sure
the horn and the light on each group work when
switching the group liftout switch on the gantry
control
WARNING
!
Repair or replace safety devices if they are not in
operating condition.
• Clean debris from the table top and the cable trough.
• Inspect the Energy Chain for loose or damaged links.
• Drain water from the coalescer on the filter regulator.
6.9.

Weekly Maintenance

• Inspect all air lines and solenoid valves to make sure
there is no air leaking (Figure 88).
• Inspect guide wheels for even wear indicating they
are positioned properly (Figure 89).
• Check that the gap between all the guide wheels
and the table frame are within 1/32nd of an inch
(Section 6.2).
• Grease the guide wheels (Figure 90).
• Using compressed air, blow out the slots containing
the acme rods on which the AutoSet Plus pucks travel.
• Visually inspect the AutoSet Plus motor coupling to
verify it is not separating from the motor.
• Visually inspect the gantry gearbox for leaks. If
the gearbox is leaking contact Alpine Equipment
Technical Support.
• Visually inspect guide assemblies for damage. If the
guides appear damaged contact Alpine Equipment
Technical Support.
36
EN
AutoSet Plus
P R O D U C T M A N UA L
Figure 88
Check for
even wear in
the center for
the wheel.
Figure 89
Grease Point
Figure 90