Move Truss Screen; Liftout Activation; Zoom Function - Alpine AutoSet Plus Manuel

3.6.2. Move Truss Screen

If jogging the truss does not resolve the setup error,
click the Move Truss button (Section 3.3) on the Truss
Setup Screen (Figure 33) to open Move Truss screen
(Figure 38).
6
Figure 38
To move a truss to an exact location using Move Truss
screen follow the steps below referring to Figure 38:
Select the direction of the movement:
1. Move truss left
2. Move truss right
3. Move truss up
4. Move truss down
Then
5. Enter the dimension to move in Feet, Inches,
Sixteenths
6. Click OK to move truss
7. Click Exit to exit the Move Truss screen and
return to the Truss Setup Screen

3.6.3. Liftout Activation

When a truss is setup on a group, the liftouts of that
group will automatically be activated. When the
gantry operator lifts a truss all the activated liftouts
of the group will operate (See section 4.2 for gantry
operation).
The AutoSet Plus software allows the operator to
deactivate or activate any liftout from the control screen
by clicking on the individual liftout.
For example, when setup a truss on Group 1, all Group 1
liftouts will automatically be activated. Clicking on any
liftout of Group 1 will deactivate it. Another click on the
same liftout will activate it again.
3.7.

Zoom Function

The AutoSet Plus software provides the following
zooming functionalities (Figure 39):
5
1
2
3
1. Zoom In: Enlarge current view by 10% per click
4
2. Zoom Out: Reduce current view by 10% per
click
7
3. Zoom to an area on the screen: to zoom any
area of a truss, click on zoom button (3) then:
• Click on the top/left Conner of the zoom area
(Figure 40)
• Click on the bottom/right Conner of zoon
area (Figure 41)
• The selected area will be displayed in a zoom
mode (Figure42)
21
AutoSet Plus
P R O D U C T M A N UA L
1 2 3 4 5
Figure 39
Figure 40
Figure 41
EN