Appendix B - Maintenance Checklist - Alpine AutoSet Plus Manuel

Appendix B – Maintenance Checklist
AutoSet Plus Table System
Machine Inspection Guide and Maintenance Log
DAILY (Section 6.6)
Safety devices a
Clean debris from table top and cable track
Inspect cable track (Energy chain) for loose or damaged links
Drain water from Filter/Regulator coalesceron
WEEKLY (Section 6.7)
Inspect air lines and solenoid valves for leaks
Inspect guide wheels for wear
Grease guide wheels
Inspect the gantry gearbox for leaks
Inspect the motor and coupling to see that they are not slipping or separating
Inspect the motor and motor mount hardware
Blow off acme rods
Run pucks full length of table, up and back, to clean acme rods
Inspect glide assemblies for damage
Wipe the liftout protection photo sensors using a dry towel
MONTHLY (Section 6.8)
Inspect the gantry drive chain tension
Lubricate the gantry drive chain
Check squareness of gantry head
Inspect and lubricate acme rods as needed
QUARTERLY (Section 6.9)
Grease the roll bearings on both ends of gantry – 2 pumps NLGI grade No.2
Inspect load runners on bottom track
Check guide wheel clearance
Inspect the distance from the load runner surface to bottom track surface
Grease bearings on automated axis of table
YEARLY (Section 6.10)
Inspect leveling leg jam nuts and verify that table surface is level
Tighten center support legs
Check for loose or missing hardware
Check the gantry gear box fluid level
— PLEASE MAKE PHOTO COPIES OF THIS FORM FOR LOGGING MAINTENANCE —
Mon Tue
45
EN
AutoSet Plus
P R O D U C T M A N UA L
Date _______/_______/_______
Wed Thur Fri Sat Sun