Alpine AutoSet Plus Manuel page 32

5. Loosen bearing's set screws (Figure 75)
Figure 75
6. Remove bearing plate. Use the ½" square drive
to turn the axis and push the plate off, then the
plate can be pulled by hand (Figure 76)
Figure 76
7. Pull guide blocks out of the table and set them
down (Figure 77)
The guide blocks are connected and will not pull all the way out.
8. Remove motor mounting screws on the
opposite end of the table (Figure 78)
32
AutoSet Plus
P R O D U C T M A N UA L
NOTICE
Figure 77
Figure 78
EN