Gate Travel Auto-Programming - SOMFY FREEVIA Mode D'emploi

2.3 Gate travel auto-programming

Prerequisite - before starting auto-programming, check that:
• The installation is switched on:
the indicator light flashes (twice).
IMPORTANT
If the gate is open once auto-programming is complete:
1. Clear the settings (see page 18).
2. Switch the motor off.
3. switch the wires connected to terminals 10 and 11 (green M1 label) of the control electronics (see
"Motor wiring", page 4).
4. Unlock the motor.
5. Position the gate at its mid-point.
Lock the motor.
6.
7. Switch the motor on.
8. Starting the auto-programming process again.
During the auto-programming process, pressing button 1 on the remote control or the
the control electronics causes the gate and the auto-programming process to stop.
• The gate is at its mid-point.
• The motor is locked.
Press the button on the control electronics.
• The gate opens, closes, opens partially and
closes again.
• The indicator light is lit constantly.
Auto-programming has been successfully
completed and the motor is operational.
If the indicator light flashes (twice), begin
the auto-programming process again.
The gate must be closed once auto-
programming is complete.
If the gate is open, see the IMPORTANT box
below.
EN - Replacing the FREEVIA electronics unit - SOMFY
button on
7