CIAT AirControl CTA Manuel De Régulation page 126

Reopen ETS5 and open the project "AHU_plugin_ETS5"
Copy and stick the model of the plugin as often as of devices to be integrated into your project. The address of every device
increments automatically. If necessary, you can change manually the address of a device in "Properties".
5.5.3 2 Assigning the physical address
The physical address of the KNX board is assigned using the standard ETS procedure.
You must ensure that:
. the Bus wire network is drawn out and connected
. the Bus is energised
. the optional KNX board is connected to the network
. the controller is powered on
EN - 60