Read-Only Parameters Menu - CIAT AirControl CTA Manuel De Régulation

Input direction se2
R.A fan control NC
-
Humidifier control NC
Burner control
Burner fault NC
Overheating therm. NC
Input direction se3
Wheel control NC
Load shedding-Choice NO
Output direction ss1
Danger NC
Maintenance NC

2.5 Read-only parameters menu

2.5.1 Inputs
i0
Supply air --.-°C
Return air --.-°c
Fresh air --.-°c
Water system --.-°c
---.-%
Humidity ---.-%
i1
Fan pressure
Supply air ------Pa
Return air ------Pa
Fan flow rate
Supply air ------m3/h
Return air ------m3/h
Duct pressure ----Pa
Level 3 access
Direction of the return air fan sensor information during operation
Direction of the humidifier check information during operation
Direction of the burner control information when "On"
Direction of the burner fault control information during operation
Direction of the burner safety control information during operation
Level 3 access
Direction of the rotary recovery control information during operation
Direction of "Bypass/Selection" control information
Level 3 access
Controller contact state when there are no "Danger" faults (NO or NC)
Controller contact state when there are no "Maintenance" faults (NO or NC)
Supply air temperature value
Controlled temperature value (return or ambient )
Fresh air temperature value
Network water temperature value
Humidity value
Supply air fan pressure value
Return air fan pressure value
Return air fan flow rate value
Return air fan flow rate value
Supply air duct pressure value
EN - 29
EN