General Description Of The Screens; Esc Button - CIAT AirControl CTA Manuel De Régulation

Connector J22
C16 Shared
NO16 Motor control of rotary heat recovery or the brine pump (optional)
NO17 Adiabatic humidifier control (Option)
NO18 ----------
C16 Shared
Connector J24
+5 Vterm Outdoor terminal power supply
GND Shared
+5 Vref Power supply for enabled sensors
1.6.1 Other
Connector J9
Not used
Connector J10
6-channel connection for an HMI terminal
Connector J11
Rx-/Tx- RS485 link for the pLAN network
Rx+/Tx+ RS485 link for the pLAN network
GND RS485 link for the pLAN network
Connector J23
Not used

2 GENERAL DESCRIPTION OF THE SCREENS

2.1 Esc button

U:01 Indicates the unit's address
Indicates the request to switch the machine on or off
Indicates the presence of hourly or annual programming and the request status
00.0°C Indicates the set temperature (ambient, exhaust or intake)
00:00 Indicates the time
Off Indicates the state of the unit: on, off, on after a power failure, standby, switched off by a fault, switched off
by CMS, post ventilation, manual mode, night cooling
Indicates the "Cooling" operating mode
Indicates "Heating" operating mode
Indicates the "Dehumidification" operating mode
Indicates the "Humidification" operating mode
Indicates the "Free Cooling" operating mode
U :01
00.0°c
Arrêt
EN - 18
00:00
Indicates Fire alarm
Indicates the operation of the fan(s)