CIAT AirControl CTA Manuel De Régulation page 96

i2
Filters
1 Supply air ------Pa
2 Return air ----Pa
3 Additional ----Pa
Air quality ----ppm
Heat recovery unit ----Pa
Supply air fan
Return air fan
Fire
Wheel control
pump control
Humidifier control -
Elec heater load shedding ---
Remote control -
Note: The Heating Selection function is used to choose between the electric heater and the Heating coil 1.
Elec. heater safety -
Damper end of travel
Frost protection thermostat.
-
Burner control -
Burner fault -
Overheating thermost. -
Heat pump control
Note: The Heating Selection function is used to choose between the electric heater and the Heating coil 1.
2.5.2 Outputs
o1
Supply air. ---%
Return air variable drive ---%
Coil 1 Cooling. ---%
Coil 2 Heating ---%
Wheel speed ---%
Humidifier ---%
Supply air filter 1 fouling value
Return air filter 2 fouling value
Additional filter 3 fouling value
CO2 air quality value
Heat exchanger fouling value
i3
Supply air fan operation check state (C = on; O = off)
-
Return air fan operation check state (C = on; O = off)
-
Fire detection sensor control state (C = no fire; O = fire detected)
-
Rotary recovery module control state (C = no fault; O = fault)
-
State control of the collector pump brine (F = no fault, O = default)
i4
-
-
Humidifier check state (C = no faults; O = fault detected)
Bypass or Heating Selection control state (On = Bypass; HW = hot water)
Remote control state (C = on; O = off)
i5
State of electric heater safety thermostat (C = fault detected; O = no faults)
State of damper limit switch contact (C = damper open; O = damper closed)
-
Frost protection thermostat state (C = fault detected; O = no faults)
Burner operation control state (C = on; O = off)
Burner operation state (C = fault detected; O = no faults)
Overheating thermostat state (C = fault detected; O = no faults)
Heat pump control state (C = fault detected; O = no faults)
-
Supply air fan variable frequency drive control value
Return air fan variable frequency drive control value
Water coil No.1 valve control value in "Cooling" mode (or Heating)
Water coil No.2 valve control value in "Heating" mode (or Cooling)
Heat exchanger wheel speed control value
Humidifier control value
-
EN - 30