Mobile Connectors Cabling (Ethernet, Poe+) - Videotec NVX220W01A Manuel D'instructions

8.2.3 Mobile connectors cabling
(Ethernet, PoE+)
If the device is not equipped with a video
analytics board, it can be powered with PSE
(Power Sourcing Equipment) in compliance
with IEEE 802.3at (PoE+).
Use Ethernet cables with the characteristics
outlined below.
• Diameter: from 5mm (0.2in) up to 6mm
(0.24in).
• Shielding: SF/UTP.
• Category: 5e.
• Length: 100m (328ft) max (PoE+).
Cable the mobile connector by operating as follows.
Insert the Ethernet cable using the sealing nut (01),
the cage (02), the gasket (03) and the body of the
connector (04).
04
Fig. 26
Crimp the shielded RJ45 connector supplied.
Connect the sleeve to the shielded RJ45
connector.
MNVCNVX_2110_EN
03 01
02
Carry out the connections as described in the table
(according to the standard specifications: TIA/EIA-
568-B).
Pin8
Pin1
Fig. 27
CONNECTION OF THE ETHERNET CABLE
Pin number Cable colour
1 Orange-White
2 Orange
3 Green-White
4 Blue
5 Blue-White
6 Green
7 Brown-White
8 Brown
Tab. 6
Fig. 28
RJ45
21