Connection Of The Power Supply Line; Connection Of The Ethernet Cable - Videotec Série 2 Manuel D'instructions

7.3 Connection of the power
supply line
Electrical connections must be performed
with the power supply disconnected and
the circuit-breaker open.
When commencing installation make sure
that the specifications for the power supply
for the installation correspond with those
required by the device.
Check that the power supply socket and
cable are adequately dimensioned.
Depending on the version, the device can be
provided with different power supply voltages. The
power supply voltage is indicated on the product
identification label. (4.2 Product marking, page 10).
The multicore cable has the power and earth cables
inside.
Perform the connections following the instructions
reported in the table .

CONNECTION OF THE POWER SUPPLY LINE

Cable color
Power supply 24Vac
Black 2
Black 1
Yellow/Green
Power supply 230Vac
Black 2
Black 1
Yellow/Green
Power supply 120Vac
Black 2
Black 1
Yellow/Green
Tab. 4
MNVCNXPTZ2_2032_EN
Description
(N) Neutral
(L) Phase
Safety earth
(N) Neutral
(L) Phase
Safety earth
(N) Neutral
(L) Phase
Safety earth
7.4 Connection of the Ethernet
cable
The Ethernet cable shield on the operator
side must always be earthed via the
connector.
Use a shielded RJ45 connector for the crimping of the
Ethernet cable.
Carry out the connections as described in the table
(according to the standard specifications: TIA/EIA-
568-B).

CONNECTION OF THE ETHERNET CABLE

Pin number Cable color
1 Orange-White
2 Orange
3 Green-White
4 Blue
5 Blue-White
6 Green
7 Brown-White
8 Brown
Tab. 5
The example below shows a typical installation.
Personal
Computer
Fig. 14
Switch
19