Safety Rules - Videotec NVX220W01A Manuel D'instructions

It is therefore indispensable that risk analysis linked
to IT security aspects, also in relation to applicable
local standards on personal data protection, are
performed by specialist staff responsible for end use
of the product.
The user of the product therefore, availing of
specialist staff in IT security, has to decide under his/
her exclusive responsibility whether to:
• Enable certain or all security functionalities offered
by the VIDEOTEC S.p.A. device;
• Implement different security measures at system
level;
• Combine the two options.
The aforementioned choice should be made based
on the specific technical and legislative context, as
well as the type of data processed using the video
surveillance system.
Given the type of technical contexts within which
VIDEOTEC S.p.A. devices are typically used, it is
not possible or would it ever be advisable that the
firmware for these devices automatically upgrades via
the Internet. Over time, VIDEOTEC S.p.A. could release
security upgrades for its devices, which should be
manually installed by the user, always by specialist
staff, if certain or all the security functionalities for
the device provided are enabled. The user is obliged
to be updated viaVIDEOTEC S.p.A. institutional
communication channels on the availability of
firmware security upgrades.
8

4 Safety rules

CAUTION! The electrical system to which
the unit is connected must be equipped
with a 10A max automatic bipolar circuit
breaker. This circuit breaker must be of
the Listed type. The minimum distance
between the circuit breaker contacts must
be 3mm (0.1in). The circuit breaker must be
provided with protection against the fault
current towards the ground (differential)
and the overcurrent (magnetothermal).
CAUTION! Device installation and
maintaining must be performed by
specialist technical staff only.
CAUTION! TNV-1 installation type. The
installation is type TNV-1, do not connect it
to SELV circuits.
CAUTION! For continued protection against
risk of fire, replace only with same type and
rating of fuse. Fuses must be replaced only
by service personnel.
• The manufacturer declines all responsibility
for any damage caused by an improper use
of the appliances mentioned in this manual.
Furthermore, the manufacturer reserves the right
to modify its contents without any prior notice.
The documentation contained in this manual has
been collected and verified with great care. The
manufacturer, however, cannot take any liability
for its use. The same thing can be said for any
person or company involved in the creation and
production of this manual.
• Before starting any operation, make sure the
power supply is disconnected.
• Be careful not to use cables that seem worn or old.
MNVCNVX_2110_EN