Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
CONTENTS
1.
GENERAL
1.1.
Pump description
2.
3.
4.
5.
5.1.
5.2.
5.3.
6.
6.1.
6.2.
6.3
6.4
6.5
6.6
6.6.1
6.6.2
6.6.3
7.
8.
9.
10.
11.
12.
12.1
12.2
12.2.1
12.3
12.3.1
12.3.2
13.
14.
15.
PART DRAWINGS
1.
GENERAL
Read this documentation carefully before installation. It contains fundamental instructions to help
you get to know the pump so that you can make the best use of its various possibilities of
application. Observing these indications will ensure long life of the pump parts and avoid risks. The
manual must always be kept within reach in the place where the machine is to be used.
Installation and functioning must comply with the safety regulations in force in the country in which the
Product is installed. The entire operation must be carried out in a workmanlike manner, exclusively by
skilled personnel (paragraph 6.1), in possession of the technical qualifications indicated by the standards
in force. Failure to comply with the safety regulations not only causes risk to personal safety and damage
to the equipment, but invalidates every right to assistance under guarantee. The pump may be installed
in either horizontal or vertical position, as long as the motor is always above the pump.
1.1. Pump description:
Example:
Type range:
TWO-POLE MOTOR = P
FOUR-POLE MOTOR = M
With standardised motor and coupling
Nominal diameter of discharge port
Nominal impeller diameter
Actual impeller diameter
Cod for materials:
A = Cast iron
B = Cast iron with bronze impeller
Wear rings ( only when there is )
Code for shaft seal:
Motor power in kW
Poles:
4 = 4 poles
2 = 2 poles
ENGLISH
-
50
-
250
/
263
A W / BAQE
21
page
21
21
22
22
22
22
22
22
22
22
22
23
23
23
23
23
23
23
23
23
25
25
25
26
26
26
26
26
27
27
27
27
27
110
/
4 / 4
Publicité
Chapitres
Table des Matières
