The Keypad And The Display - DAB e.sybox Instructions Pour L'installation Et L'entretien

6 - THE KEYPAD AND THE DISPLAY

Figure 13: Aspect of the user interface
The user interface is composed of a keypad with 128x240 pixel LCD
display and with POWER, COMM, ALARM warning leds as can be seen
in Figure 13.
The display shows the values and the statuses of the device, with indica-
tions on the functionality of the various parameters.
The functions of the keys are summed up in Table 4.
The MODE key allows you to move on to the next items in the same
menu. Holding it down for at least 1 sec allows you to skip to previous
menu item.
The SET key allows you to leave the current menu.
Decreases the current parameter (if it is an editable parameter).
Increases the current parameter (if it is an editable parameter).
Table 7: Key functions
Holding down the "+" key or the "-" key allows the automatic increase/
decrease of the parameter selected. After the "+" key or the "-" key has
been held down for 3 seconds, the automatic increase/decrease speed
increases.
When the + key or the - key is pressed the selected value is
modified and saved immediately in the permanent memory
(EEprom). If the machine is switched off, even accidentally, in
this phase it does not cause the loss of the parameter that has
just been set.
The SET key is only for leaving the current menu and is not
necessary for saving the changes made. Only in particular
cases described in chapter 0 are some values updated by
pressing "SET" or "MODE".
Warning leds
• Power
White led. Lit with a fixed light when the machine is powered.
Blinking when the machine is disabled (see par. 5.5).
• Alarm
Red led. Lit with a fixed light when the machine is blocked by an
error.
• Communication
Blue led. Lit with a fixed light when communication wireless is
GB
ENGLISH
79