Ad: Address Configuration; Ms: Measuring System; As: Association Of Devices - DAB e.sybox Instructions Pour L'installation Et L'entretien

GB
ENGLISH
IMPORTANT: The regulating parameters GP and GI also change in the
two configurations. In addition the GP and GI values set in mode 1 are
stored in a different memory from the GP and GI values set in mode
2. So, for example, when passing to mode 2, the GB value of mode 1
is replaced by the GB value of mode 2 but it is kept and will reappear
again when returning to mode 1. The same value shown on the display
has a different weight in one mode or in the other because the control
algorithm is different.

7.5.3 - AD: Address configuration

This is significant only in a multi-pump connection. Set the communi-
cation address to be assigned to the device. The possible values are:
automatic (default) or manually assigned address.
The addresses set manually can have values form 1 to 4. The configura-
tion of the addresses must be the same for all the devices that make up
the group: either all automatic or all manual. Setting the same addresses
is not allowed.
Both in the case of assigning mixed addresses (some manual and some
automatic) and in the case of duplicate addresses, an error signal is
given. The error signal is given by displaying a flashing E in the place of
the machine address.
If the chosen assignment is automatic, whenever the system is switched
on addresses are assigned that may be different from the previous time,
but this does not affect correct operation.

7.5.4 - MS: Measuring system

Set the measuring system, choosing between metric and imperial units.
The quantities displayed are shown in Table 13.
NOTE: the flow conversion factor for the US/UK unit of measure-
ment is 1 gal = 4l.
90
Units of measurement displayed
Quantity Metric units
Pressure bar
Temperature °C
Flow rate l / min
Table 13: Measuring system

7.5.5 - AS: Association of devices

Allows connection/disconnection with the following devices
• e.sy Other e.sybox pump for operation in a pump set
• composed of max 4 elements
• COM PWM Com communication control unit
• TERM PWM Term remote control terminal
• I/O e.sylink input output control unit
• DEV Any other compatible devices
Connections menu
The icons of the various connected devices are displayed with below an
identifying acronym and the respective reception power.
An icon lit with a fixed light means that the device is connected and work-
ing correctly; a stroked through icon means the device is configured as
part of the network but is not found.
Pressing "+" or "-" allows you to select a device that is already connected
(function active on release) making the respective icon appear in reverse;
when the device is selected, a description of the selected device appears
underlined.
All the devices present over the air are not displayed on this
page but only the devices that have been associated with our
network.
Seeing only the devices in your own network allows the opera-
Imperial units
psi
°F
gal / min