ETNA A3911RVS Mode D'emploi page 90

OPeratION
GB 18
Programming the automatic baking process
1. Press the kitchen timer/timer button for 3 seconds.
The bell symbol appears and starts flashing.
2. Press the kitchen timer/timer button once again.
'dur' and 'AUTO' flash in the display, alternating with '0 00'.
3. Set the desired baking time (if the display is still flashing) with the +
and the - button and wait for an audible signal which indicates that
the time is saved.
The current time appears in the display and 'AUTO' stops flashing.
▷ If the display is no longer flashing you cannot set the time.
Repeat steps 1 and 2.
4. Press the kitchen timer/timer button once again for 3 seconds.
5. Press the kitchen timer/timer button once again twice in
succession.
'End' and 'AUTO' flash in the display, alternating with the current
time.
6. Set the end time (if the display is still flashing) with the + and the -
button and wait for an audible signal which indicates that the time
is saved.
The current time appears in the display and 'AUTO' stops flashing.
▷ If the display is no longer flashing you cannot set the time.
Repeat steps 1 and 2.
• Example:
Current time: 12.36
Time of baking process set: 10 minutes
Set end time of the baking process: 1400
The oven will start the baking process at 1350 at the present
temperature and will stop at 1400.
7. Once the time has passed you will hear an audible signal, 'AUTO'
will flash and the oven will switch off. Press any button in order to
switch off the audible signal. The audible signal switches off but
'AUTO' continues flashing. If you then press on the kitchen timer/
timer button for a while, 'AUTO' will disappear.