Using The Grill; Lighting Instructions - Fisher & Paykel DCS BH1-48RS Guide D'utilisation

Lighting Instructions

Grill lighting instructions
IMPORTANT!
Open the grill lid and/or remove the top grate cover from side burner (for BH1-48RS) before lighting.
Turn all knobs to "OFF". Turn the main gas supply on. If you smell gas, shut-off gas supply and call for
customer care.
Grill lighting instructions
The grill knob is connected to the electronic ignition module.
Pushing in on the burner knob will activate the ignition module to
get a spark. Push in and turn the selected burner knob to HI/SEAR
position. Release the knob when the burner lights. If burner does
not light in four to five seconds, turn knob "OFF" and wait five
minutes before trying again so any accumulated gas may dissipate.
Grill Match Lighting
If the burner will not light after several attempts, then the burner
can be match lit. If you've just attempted to light the burner
with the ignition, allow five minutes for any accumulated gas to
dissipate. Keep your face as far away from the outdoor appliance
as possible and hold a paper book match over the hole located
on the top left for burner on the left, or the right hole for the
right burner (Fig. 13). Push in and turn the control knob which is
centered on the burner where the lit match is located, to "SEAR".
If the burner does not light in four seconds, turn the knob off, wait
five minutes and try again.
IMPORTANT!
Improper lighting procedures can cause the LP tank flow control to activate, resulting in reduced
heat output. If this is suspected the flow control will need to be reset. For BH1-48RGI and BH1-36RGI
models see the Quick Start Guide for how to use the griddle and Infrared Hybrid Burner.
Resetting the flow control
IMPORTANT!
Failure to follow the steps in the order shown may cause the Flow Limiting Device to activate resulting
in extremely low gas flow and irregular operation.
1 All knobs must be in the
OFF position.

USING THE GRILL

2 Attach regulator hose
assembly to the tank.
FIG. 14
3 Open the LP tank valve.
(Two full turns min).
EN
21