Built-In Construction Details - Fisher & Paykel DCS BH1-48RS Guide D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Built-in Construction Details

Standard layout for non-combustible cavity
IMPORTANT!
If installing the grill into a non-combustible enclosure, all combustible construction must still be
outside the 18" (457mm) clearance zone. If your island is made of stucco over the top of wooden
studs, the wood can not be inside the 18 inch clearance zone to combustible, even though the
stucco is what is touching the grill area.
Note: The enclosure should have
ventilation holes to prevent gas
build-up in the event of a leak.
Refer to ANSI Z21.58 Standard for
Outdoor Cooking Gas Appliances,
Section 1.7 Enclosures For Self
Contained LP-Gas Supply Systems.
CAVITY DIMENSIONS
Maximum height of enclosure shell
A
Depth of enclosure shell
B
Minimum depth for hood swing
Standard layout for non-combustible enclosure:
C
Width of enclosure cavity
D
Height of enclosure cavity
E
Depth to gas supply opening
f
2
"2
64,5 cm
/10
min.
ventilation on
Height of opening for access doors/drawers
G
the back side
Width of opening for access doors/drawers
H
2
"2
64,5 cm
min
/10
ventilation left
25,72 cm/
10 1/8"
12
2,54 cm/1" min.
INSTALLATION
G
48" Models = 116,2 cm/45 3/4 "
36" Models = 87,6 cm/34 1/2 "
46.36 cm/
18 1/2 "
D
C
F
E
H
FIG. 04
NOTE: If using a backguard
apron or rear wall, locate
electrical service on the
right hand side for rotisserie
motor connection
9,5cm/3 3/4" min. for Lid
57,79 cm/22 3/4"
10,16 x 10,16cm
(4 x 4")
opening for gas
supply line
Note: 4x4" (102 x 102mm)
opening for gas supply line.
B
A
Note: the cut-out of
each corner should be a
90°angle in order for the
access doors/drawers to
fit properly.
BH1-48R
Inches (mm)
35 1/2 (902)
22 3/4 (578)
3 3/4 (95)
45 3/4 (1162)
10 1/8 (257)
WARNING!
18 1/2 (470)
If installing the grill into
20 (508)
a non-combustible
enclosure, all combustible
46 (1168)
construction must still be
outside the 18 inch
clearance zone. If your
island is made of stucco
over the top of wooden
studs, the wood can not
be inside the 18 inch
clearance zone to
combustible, even though
the stucco is what is
touching the grill area.
BH1-36R
Inches (mm)
35 1/2 (902)
22 3/4 (578)
3 3/4 (95)
34 1/2 (876)
10 1/8 (257)
18 1/2 (470)
20 (508)
34 (864)

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Dcs bh1-36rgiDcs bh1-36r

Table des Matières