Description Of Power Supply Interface Connections; Scope Of Delivery; Required Tools; Installation And Electrical Connection - Webasto Live 11 Notice D'utilisation

tion (prerequisite: connection to the back end or to the
EN
local power management system). A category 5e network
cable or higher is recommended.
3.1.5 USB type B
Connecting in slave mode for making a USB connection
to a computer for the configuration. When connected to
a computer, this USB connection functions like a network
interface, and is used to open the web configuration in-
terface
(see online configuration instructions: https://webasto-
charging.com/documentation).
3.1.6 WLAN
After completing the start process of the charging station,
you have the option to connect a WLAN-enabled com-
puter or mobile device to the charging station hot spot
(see online configuration instructions: https://webasto-
charging.com/documentation)
Only the configuration interface can be opened using the
established connection.
3.1.7 Control cable (Control Pilot)
See also Fig. 3
Legend
Modbus
CP connection (push-in terminal)
There also is a data line in the charging cable together
with the power supply lines and is known as a CP (control
pilot) line. This line (black-white) is inserted into the push-
in terminal on the CP connection
stalling the original charging cable and also to replacing
the charging cable.
3.2 Description of power supply interface
connections
See also Fig. 4
The connections of the mains cable are marked with "IN".
The 5 terminals on the left have L1/L2/L3/N/PE printed on
them
The connections of the charging cable are marked with
"OUT". The 5 terminals on the right have PE/N/L1/L2/L3
printed on them
14
NOTE
To release the power supply connections, use an
insulated flat-head screwdriver by inserting it
into the opening for this purpose immediately
above push-in terminal.
All dimensions specified in mm.
4

Scope of delivery

Scope of delivery
Charging station
Charging cable with charging coupling
RFID dongle
Installation kit for wall mounting
– Wall plug (8 x 50 mm, Fischer UX R 8)
– Screw (6 x 70, T25)
– Screw (6 x 90, T25)
– Washer (12 x 6.4 mm, DIN 125-A2)
– Screw (3 x 20 mm, T10)
– Mounting bracket
– Cable bushing, (one is custom-made)
Installation kit for charging cable:
– Spiral antikink protection
– Cable tie
– Cable clamp
– Screw (6.5 x 25 mm, T25) for fastening the
cable clamp
Operating and installation instructions
. This applies to in-
5

Required tools

Tool description
Slot-head screwdriver 0.5x3.5 mm
Torx screwdriver Tx25
Torx screwdriver Tx10
Torque wrench (range covers 5-6 Nm, for Tx25)
Torque wrench (range covers 4-5 Nm, for
open-ended spanner size 29)
Drilling machine with 8 mm drill
Hammer
Tool description
Measuring tape
Spirit level
Wire stripping tool
Installation tester
EV simulator with rotary field display
Amount Round file
Combination pliers
1
1 6

Installation and electrical connection

Observe the safety information provided here
2
chapter 2 "Safety".
NOTE
4
In addition to these operating and installation in-
2
structions, follow and comply with the local reg-
2
ulations relating to operation, installation and
4
environmental protection.
2 6.1

Requirements installation space

1 The following points must be take into account when se-
lecting the installation location for the Webasto Live:
2
– The lower edge of the enclosed mounting template
must be a minimum distance above the ground during
1
installation. The minimum distance is indicated in the
1
figure at chapter 13 "Assembly".
1
– If several charging stations are installed next to each
2 other, a spacing of at least 200 mm must be main-
tained between each station.
– The mounting surface must be solid and strong.
1
– The mounting surface must be completely flat (max. 1
mm difference between the individual mounting
Amount
points).
1
– The mounting surface must not contain any flammable
1
substances.
1
– The normal parking position of the vehicle.
1 – The location of the charging plug on the vehicle.
– A cable run from the charging station to the vehicle as
1
short as possible.
– No risk of driving over the charging cable.
1
– Possible electrical connections.
1
– Pavements and escape routes must not be obstructed.
5110326B OI II Webasto Live Multilanguage
Amount
1
1
1
1
1
1
1