General Information; Purpose Of The Document; Using This Document; Intended Use - Webasto Live 11 Notice D'utilisation

1

General information

EN
1.1

Purpose of the document

These operating and installation instructions are part of
the product and contain information for the user to en-
sure safe operation and for the electrician to carry out
safe installation of the Webasto Live charging station.
1.2

Using this document

u Carefully read the operating and installation instruc-
tions before installing and starting up the Webasto
Live.
u Keep these instructions ready to hand.
u Hand these instructions on to the following owner or
user of the charging station.
1.3

Intended use

The Webasto Live charging station is designed for char-
ging electric vehicles in accordance with IEC 61851-1,
charge mode 3. In this charge mode, the charging station
ensures:
– The voltage is not applied before the vehicle has been
connected correctly.
– The maximum power is calibrated.
The AC/DC converter is in the vehicle.
1.4

Use of symbols and highlighting

DANGER
This signal word denotes a hazard with a high
degree of risk which, if not avoided, will lead to
death or serious injury.
WARNING
This signal word denotes a hazard with a moder-
ate degree of risk which, if not avoided, may
lead to minor or moderate injury.
CAUTION
This signal word denotes a hazard with a low de-
gree of risk which, if not avoided, will lead to
minor or moderate injury.
NOTE
This signal word denotes a Special Technical Fea-
ture or (if not observed) potential damage to the
product.
12
Refers to separate documents which are en-
closed or can be requested from Webasto.
Symbol Explanation
Requirements for the following necessary
action
Necessary action
1.5

Warranty and liability

Webasto shall not assume liability for defects or damage
that are the result of the installation and operating in-
structions being disregarded. In particular, this liability ex-
clusion applies in the following cases:
– Repairs carried out by an electrician not contracted by
Webasto
– Use of non-original spare parts.
– conversion of the unit without permission from
Webasto
– Installation and commissioning carried out by unquali-
fied staff (not an electrician).
– Improper disposal after decommissioning
1.6

Software licences

This product contains open-source software. Further in-
formation relating to this (written offer, licence informa-
tion) can be found in the dashboard under system inform-
ation, at the following address: http://192.168.123.123/
groups/system.
2

Safety

2.1 General information
The charging station has been developed, produced,
tested and documented according to the relevant safety
regulations and environmental requirements. The device
must only be used in a technically faultless condition.
Have any malfunctions that adversely affect the safety of
persons or of the device rectified immediately by an elec-
trician in accordance with nationally applicable regula-
tions.
NOTE
It is possible that the signalling in the vehicle dif-
fers from that described here. Always read the
operating instructions of the respective vehicle
manufacturer and always observe these.
2.2

General safety information

– Hazardous voltages are present within the casing.
– The charging station does not have its own main
ON/OFF switch. The protective devices installed in
the power supply system are therefore also used
to disconnect the power supply.
– Check charging station for visual damage before
use. Do not use the charging station if damaged.
– Installation, electrical connection and initial opera-
tion of the charging station must only be carried
out by an electrician.
– Do not remove the cover of the installation area
whilst in operation.
– Do not remove markings, warning symbols and
the type label from the charging station.
– The charging cable must only be replaced by an
electrician in accordance with the installation in-
structions.
– It is strictly prohibited to connect other equip-
ment/devices to the charging station.
– When not in use, store the charging cable in the
designated holder and lock the charging coupling
in the charging station. Loosely wind the charging
cable around the charger casing so that it does
not touch the ground.
– Make sure that the charging cable and coupling
cannot be driven over, trapped and are protected
from any other hazards.
– Immediately notify Webasto Customer Service if
the charging station, charging cable or the char-
ging coupling are damaged. Do not continue us-
ing the charging station.
– Prevent the charging cable and coupling from
coming in contact with external heat sources, wa-
ter, dirt and chemicals.
– Do not attach extension cables or adapters to the
charging cable.
– Remove the charging cable by pulling on the char-
ging coupling only.
– Never clean the charging station with a high-pres-
sure cleaner or similar device.
5110326B OI II Webasto Live Multilanguage