Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
HIGH VOLTAGE WARNING
High voltage is present in your electric meter housing and power
distribution service panel. Contact with high voltage can cause death or
DANGER
serious personal injury.
................................................................................................................
................................................................................................................
DO NOT operate your charger with a damaged output cable, charge
coupler, or module. Visually inspect the output cable, charge coupler, and
WARNING
charger module for damage before each use. If you detect any damage,
stop using the charger and contact Customer Support.
................................................................................................................
................................................................................................................
ALWAYS position the charger output cable so that it will not be driven
over, stepped on, tripped over, or otherwise damaged or stressed. To
WARNING
prevent personal injury and damage to the charger, ALWAYS stow the
charger on hanger or in stowage bag after use.
................................................................................................................
................................................................................................................
Use the charger only to supply power to electric vehicles equipped with an
SAE J1772 compliant vehicle receptacle. For more information, refer to the
WARNING
vehicle owner's manual.
................................................................................................................
................................................................................................................
Disconnect the charger from the wall outlet before cleaning it. To clean
NOTE
the charger, wipe it with a clean cloth dampened with water or a mild
detergent solution suitable for use on automobile paint. Do not use
chemicals or solvents. Do not submerge the charger.
STATE OF CALIFORNIA PROPOSITION 65 WARNINGS
This product contains a chemical known to the State
WARNING
of California to cause cancer or birth defects or other
reproductive harm.
18
FCC INFORMATION
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
•
This device may not cause harmful interference.
•
This device must accept any interference received, including interference that
may cause undesired operation.
This product has been designed to protect against Radio Frequency Interference
(RFI). However, there are some instances where high powered radio signals or
nearby RF producing equipment (i.e. digital phones, RF communications equipment,
etc.) could affect operation.
If you suspect your charger is receiving interference, take the following steps before
contacting Customer Support for service:
1. Relocate nearby electrical appliances or equipment during charging.
2. Turn off nearby electrical appliances or equipment during charging.
Important!
Changes or modifications to this product by anyone other than an
authorized service provider will void FCC compliance.
SAFETY FEATURES
The charger is designed with your safety as the highest priority and includes the
following safety features to protect against the risk of electric shock:
•
Service Ground Check:
The charger constantly checks for the presence of a
service ground connection. If the service ground ever fails, the charger RED
TROUBLE Indicator turns ON and shuts down power to the vehicle.
Thermal Event Sensor:
Charger module senses out of ordinary thermal events
•
and will shut the unit down.
GFCI Protection:
The charger is equipped with a Ground Fault Circuit
•
Interruption (GFCI) reaction system to protect against electric shock. If the
charger module detects an output ground fault, it will shut down power to the
output cable and illuminate the RED TROUBLE Indicator.
•
Insulation:
The charger module, adapter, cable assembly and charge coupler are
completely insulated (no exposed live parts) to protect against electric shock.
•
Unintentional Disconnection:
The charge coupler is designed to minimize
unintentional disconnection. A pilot signal wire in the cable and charge coupler
eliminates the possibility of electric shock when not connected to a vehicle
or if an unintended disconnect occurs during a charge. Disconnection during
charging is safe.
19
Publicité
Chapitres
Table des Matières
