Front Panel - Tripp-Lite B004-2DUA2-K Manuel De L'utilisateur

Features

Front Panel

No. Component
Port Selection
1
Pushbuttons
Mode
2
Selection
Pushbutton
Port LEDs
3
Console Audio
4
Connectors
USB 2.0
5
Peripheral Port
1 2
3
Description
Pressing one of the port selection pushbuttons will bring he focus
of one of the following to the corresponding port; KVM only, Audio
only, USB only, or KVM, Audio and USB simultaneously. What
functionality is switched is determined by the Mode Selection
Pushbutton (see below).
Pressing and holding pushbuttons 1 and 2 simultaneously
for more than 2 seconds will initiate an auto scan. On the
B004-2DUA4-K, pressing and holding pushbuttons 3 and 4
simultaneously for more than 2 seconds will perform a USB
keyboard/mouse reset.
Press this pushbutton to determine the functionality that is
switched to a port when its pushbutton is pressed. Pressing the
mode selection pushbutton once highlights the KVM, Audio and
USB functionality icons all at the same time. Pressing it twice
highlights KVM only; three times Audio only; and four times USB
only.
Each port contains three LEDs; KVM, Audio, and USB. The
corresponding LED will illuminate under the port that has its
focus. For example, if port 1 has the focus of the KVM, Audio, and
USB all at the same time, then all three LEDs will illuminate under
port 1.
A separate set of Console Speaker and Microphone jacks are
located on the front panel of the unit for greater accessibility.
Devices plugged into these ports will take priority over devices
plugged into the Console Speaker and Microphone jacks on the
back panel of the unit.
USB 2.0 devices (flash drives, printers, scanners, etc.) can
be plugged into this port and shared between the connected
computers.
5
1
3 4 5