Tripp-Lite B004-2DUA2-K Manuel De L'utilisateur page 18

Basic Operation
Pushbutton 1 and 2 Command
By default, pressing pushbuttons 1 and 2 at the same time for two seconds will initiate
Auto Scan Mode, but you can set it to perform any Hotkey Setting Mode command that
you want. The Restore Default Settings, Disable Port Switching Hotkeys, and Firmware
Upgrade Mode commands cannot be used. To set the Pushbutton 1 and 2 Command,
do the following.
1. Activate Hotkey Setting Mode using the aforementioned command
2. Press and release the [C] key
3. Perform the command that you wish to set. (e.g. Press and release the [W] key to set
the Pushbutton 1 and 2 Command to turn Mouse Port Switching Functionality on/off.
To return the Pushbutton 1 and 2 Command to its default, press and release the [A] key
in step 3.
Pushbutton 3 and 4 Command
By default, pressing pushbuttons 3 and 4 at the same time for two seconds will perform
a USB Keyboard/Mouse Reset, but you can set it to perform any Hotkey Setting Mode
command that you want. The Restore Default Settings, Disable Port Switching Hotkeys,
and Firmware Upgrade Mode commands cannot be used. To set the Pushbutton 3 and 4
Command, do the following.
1. Activate Hotkey Setting Mode using the aforementioned command
2. Press and release the [C] key, and then press and release the [2] key
3. Perform the command that you wish to set. (e.g. Press and release the [W] key to set
the Pushbutton 3 and 4 Command to turn Mouse Port Switching Functionality on/off.)
To return the Pushbutton 3 and 4 Command to its default, press and release the [F5]
key in step 3.
18