Tripp-Lite B004-2DUA2-K Manuel De L'utilisateur page 16

Basic Operation
List KVM Settings
This function allows you to display a list of the current KVM settings; Hotkeys, Keyboard
OS, Keyboard Emulation, Mouse Emulation, Mouse Port Switching, Power On Detection
and Keyboard Language. To perform this function, do the following.
1. Open up a Word, Wordpad, Notepad or Excel file
2. Activate Hotkey Setting Mode using the aforementioned command
3. Press and release the [F4] key
USB Keyboard/Mouse Reset
In the event that the keyboard and mouse are not operating correctly, a reset may be
needed. To perform a USB keyboard/mouse reset, do the following.
1. Activate Hotkey Setting Mode using the aforementioned command
2. Press and release the [F5] key
Hotkey Beeper Control
When performing a keyboard hotkey command, a beeper sounds to indicate that the
command is taking place. This beeper sound can be toggled on/off by performing the
following command.
1. Activate Hotkey Setting Mode using the aforementioned command
2. Press and release the [B] key
Disable Port Switching Hotkeys
By default, Port Switching Hotkeys are available that allow you to switch between ports.
To disable the Port Switching Hotkeys and require the front panel pushbuttons to be used
for switching functions, do the following.
1. Activate Hotkey Setting Mode using the aforementioned command
2. Press and release the [x] key and then press and release the [Enter] key
Firmware Upgrade Mode
The B004-2DUA2-K and B004-2DUA4-K firmware can be upgraded as updates become
available on Tripp Lite's website (See the Firmware Upgrade section in this manual for
details). In order to perform a firmware upgrade, Firmware Upgrade Mode must first be
initiated. To initiate Firmware Upgrade Mode, do the following.
1. Activate Hotkey Setting Mode using the aforementioned command
2. Key in the text "upgrade"
3. Press and release the [Enter] key
The LEDs on the front of the KVM flash to indicate that Firmware Upgrade Mode has
been initiated.
Restore Default Settings
To restore the KVM to its factory default settings, do the following.
1. Activate Hotkey Setting Mode using the aforementioned command
2. Press and release the [R] key, and then press and release the [Enter] key
16