Tripp-Lite B004-2DUA2-K Manuel De L'utilisateur page 12

Installation
8
Optional – Connect your microphone and speakers to the corresponding 3.5 mm
Mini Stereo console jacks on the front panel or the back panel of the Host KVM
switch. The jacks on the front panel of the unit will take priority over those on the
back panel. The 3.5 mm Mini Stereo console ports on the Client KVM switch can
remain open.
9
Optional – Connect your USB device(s) to the USB 2.0 hub port(s) on the front and
back of the Host KVM switch.
10
Optional – Connect your USB device(s) to the USB 2.0 hub port(s) on the front and
back of the Client KVM switch.
Note: The USB ports on the back of the Client KVM must be connected to the computers for
these ports to work. See step 16.
11
Connect the end of the KVM Cable Kit that includes the USB Type B Male connector
to an available set of computer ports on the back panel of the Host KVM switch.
Connect the DVI connector to the DVI A port, and the USB and 3.5 mm connectors
to the corresponding USB and 3.5 mm ports.
12
Connect the other end of the KVM Cable Kit to the corresponding ports on the
computer you wish to add to the installation.
Note: The B004-2DUA2-K and B004-2DUA4-K come with 6 ft. Cable Kits. If you need a
longer cable, use a P759-Series DVI/USB + Audio KVM Cable Kit (sold separately), available in
lengths up to 15 ft.
13
Connect a DVI cable to the DVI B port on the back of the Host KVM switch, and
then into a DVI port on the computer being added to the installation.
Note: The B004-2DUA2-K and B004-2DUA4-K come with 6 ft. DVI-D Dual Link Cables. If you
need a longer cable, use a P560-Series (DVI-D Dual-Link) or P561-Series (DVI-D Single-Link
cable (sold separately), available in lengths up to 10 ft.
14
Connect a DVI cable to the DVI A port on the back of the Client KVM switch, and
then into a DVI port on the computer being added to the installation.
15
Connect a DVI cable to the DVI B port on the back of the Client KVM switch, and
then into a DVI port on the computer being added to the installation.
16
In order for the USB 2.0 Hub functionality of the Client KVM switch to work, the USB
computer ports on the back of the Client KVM must be connected to USB ports on
the computers being added to the installation. If you are using this functionality,
connect the USB computer port on the Client KVM switch to a USB port on
the computer being added to the installation using a standard USB 2.0 cable.
Otherwise, the USB and 3.5 mm Mini Stereo KVM ports on the Client KVM switch
can remain open.
17
Repeat steps 11 through 16 for each additional computer you are adding to the
installation.
18
Connect the included power supplies to the KVM switches, and then plug them into
an appropriate power source. To help protect your system from sudden transient
increases and decreases in electrical power, it is recommended that you plug your
devices into a Tripp Lite surge protector, line conditioner, or uninterruptible power
supply (UPS).
19
Turn on the power to all connected devices.
12